making the bracket fit the bolt location. I actually removed the wrong bridge between holes and ended up removing the next inward bridge also. Measu

These are the bracket type supplied with the pro-series 30056 kit. Two are slanted and two straight.

making the bracket fit the bolt location. I actually removed the wrong bridge between holes and ended up removing the next inward bridge also. Measu

Hitch about 4 inches behind the axle. 28 inches from cab.

Finished hitch. You can see the 4 inches rear of wheel wells. The Bedrug was cut up and reinstalled in 3 pieces.

Left rear beacket installed. Each bracket was installed up against the bed-to-side joint weld interface. A 1-3/8 spacer between bracket and bed. Sto

Left front bracket installed. The position inside the frame rail for the bolt from the hitch rail is very limited by interferences. A fastening tab

Left rear marked. A backing plate of 1/4 steel was fabricated for the second stud and inserted behind the large hole in the rail.

making the bracket fit the bolt location. I actually removed the wrong bridge between holes and ended up removing the next inward bridge also. Measu

john o-ESC
Aug 7, 2016

There are no comments to display.