SOLD: 2021 FWC Grandby and 2022 F250 flatbed

mr.freit

New Member
Joined
Feb 11, 2022
Messages
4
[SIZE=11pt]In a great example of “best laid plans often go awry”, we’re selling our 2021 FourWheel Camper Grandby flatbed rig. We had big plans for this rig and our family, however, some recent arrivals (twins!) have forced us to reconsider our priorities. We hope someone here will get to benefit from this fun adventure rig. [/SIZE]

[SIZE=11pt]The entire rig is essentially brand new. We purchased the Grandby last September and our truck was delivered in December and the Norweld tray installed soon after. The Grandby is scheduled to be installed onto the flatbed by FWC on 2/24/22. So it’s a turnkey adventure rig without any wait or lead times. [/SIZE]

[SIZE=11pt]Price: $115,000 for the whole rig. Would consider selling camper and truck separately if camper sold first. $45K for camper and $70K for truck. PM or email me at [/SIZE][SIZE=11pt]2021Grandby@gmail.com[/SIZE][SIZE=11pt] if you’re interested. Happy to answer any questions. [/SIZE]

[SIZE=11pt]Build:[/SIZE]
[SIZE=11pt]2021 FourWheel Camper Grandby Flatbed[/SIZE]

  • [SIZE=11.5pt]130 L way refrigerator/Freezer[/SIZE]

  • [SIZE=11.5pt]Forced Air Furnace with thermostat[/SIZE]

  • [SIZE=11.5pt]DSI 6 gallon water heater with outside and inside shower and 20 gallon water tank[/SIZE]

  • [SIZE=11.5pt]King size bed (has slide outs) and massive underbed storage[/SIZE]

  • [SIZE=11.5pt]Two 160W solar panels w/controller and there is an additional portable solar panel plug on rear of camper[/SIZE]

  • [SIZE=11.5pt]Two deep cycle battery (180Ah)[/SIZE]

  • [SIZE=11.5pt]12 Volt receptacle and USB outlets[/SIZE]

  • [SIZE=11.5pt]Flush Mount Glass Top Sink/Stove upgrade[/SIZE]

  • [SIZE=11.5pt]Cassette toilet[/SIZE]

  • [SIZE=11.5pt]1 roof fan and 1 roof vent[/SIZE]

  • [SIZE=11.5pt]Fiamma awning[/SIZE]

  • [SIZE=11.5pt]Yakima Roof Racks[/SIZE]

  • [SIZE=11.5pt]Aluminum wall steps[/SIZE]

  • [SIZE=11.5pt]3 propane tanks[/SIZE]

  • [SIZE=11.5pt]Rear and side LED floodlights+ low side lighting[/SIZE]

  • [SIZE=11.5pt]Thermal pack [/SIZE]

  • [SIZE=11.5pt]Silver spur Interior[/SIZE]

  • [SIZE=11.5pt]Rear rack with propane tank mount and a backup camera (not hooked up)[/SIZE]

  • [SIZE=11.5pt]4 jack stands and plates[/SIZE]

[SIZE=11pt]2022 Ford F250 - brand new truck. Less than 500 miles driven. [/SIZE]

  • [SIZE=11pt]XL SuperCrew (176” W:cool:[/SIZE]

  • [SIZE=11pt]6.2L V8 (gasoline) with 6 speed transmission[/SIZE]

  • [SIZE=11pt]4.30 electronic locking axle [/SIZE]

  • [SIZE=11pt]10,000 GVWR package[/SIZE]

  • [SIZE=11pt]240 Amp alternator (already hooked up to Norweld to charge camper)[/SIZE]

  • [SIZE=11pt]FX4 off road package[/SIZE]

  • [SIZE=11pt]Camper package (upgraded rear springs and rear sway bar)[/SIZE]

  • [SIZE=11pt]SYNC3 system with 8” screen[/SIZE]

  • [SIZE=11pt]100V/400W outlets[/SIZE]

  • [SIZE=11pt]Power windows/locks[/SIZE]

  • [SIZE=11pt]Cruise control[/SIZE]

  • [SIZE=11.5pt]Brand new 8’ Norweld tray with 4 boxes, rear center storage tray, and 10 gallon water tank[/SIZE]

  • [SIZE=11.5pt]Custom steel bumper with backup camera and trailer wiring attached. [/SIZE]

[SIZE=11pt]Location: Nevada City, CA[/SIZE]

[SIZE=11pt]Known Defects: The aluminum sheeting roof was minorly damaged (indented between roof supports) by snow load during a recent storm. There are no leaks (we’ve checked) and no damage to the solar and electrical, but if the camper is sitting dead level a few spots will hold about a quarter inch of water. If it’s parked on even a minor slope, it’s not an issue at all.[/SIZE]
 

Attachments

  • IMG_1680.jpg
    IMG_1680.jpg
    40.9 KB · Views: 242
  • IMG_1676.jpg
    IMG_1676.jpg
    46.2 KB · Views: 253
  • IMG_1677.jpg
    IMG_1677.jpg
    45.8 KB · Views: 290
  • IMG_1678.jpg
    IMG_1678.jpg
    47 KB · Views: 278
  • IMG_1681.jpg
    IMG_1681.jpg
    47.3 KB · Views: 285
  • IMG_1682.jpg
    IMG_1682.jpg
    30.8 KB · Views: 266
  • IMG_1683.jpg
    IMG_1683.jpg
    26.2 KB · Views: 247
  • IMG_1684.jpg
    IMG_1684.jpg
    25.1 KB · Views: 265
  • IMG_1685.jpg
    IMG_1685.jpg
    26.4 KB · Views: 254
  • IMG_1687.jpg
    IMG_1687.jpg
    30.4 KB · Views: 251
Thanks! We had the tray installed by FourWheel Campers in Woodland, CA. It came out super clean except for the gap btw the hitch and bottom of the tray- so we had that steel bumper fabricated to clean that up.
 
Could you post some pictures of the damage to the top. Or email to dlearned1@gmail.com,

Thanks
 
Update to this thread. Camper was installed on the truck on 2/24 (photos below) looks and drives awesome.

FWC also inspected the roof damage and determined that the roof is totally functional and structurally sound.
 

Attachments

  • IMG_1710.jpg
    IMG_1710.jpg
    98 KB · Views: 156
  • IMG_1713.jpg
    IMG_1713.jpg
    97.9 KB · Views: 107
  • IMG_1718.jpg
    IMG_1718.jpg
    91.7 KB · Views: 121
  • IMG_1719.jpg
    IMG_1719.jpg
    90 KB · Views: 137
  • IMG_1720.jpg
    IMG_1720.jpg
    95 KB · Views: 88
Back
Top Bottom