Search results

I believe this is a correct install. Not a 4 wheel camper, but roughly same floor pack. 3 years and no problems.

Here is my diesel heater install. Been using it 3 years now. Jan 2. 2024 thru Feb 16 in Ouray, CO. Ice climbing. Back to CO in May for 3 weeks spring alpine season this year. It is cold up there that time of year. No problems with heater. Headed back in Jan 2025. Still same cheap heater in home...

You can buy that latch any place that sells horse trailers. This is not new. Our Sundowner horse trailer came with these 20 years ago.

I used Sherwin Williams porch and step paint. Very tough paint.

I put a diesel heater in my home built camper. I like it. I don’t think it it loud inside or outside the camper. I used it 27 days in SW Colorado for ice climber season. I have a fuel tank on back of camper so I can mix kerosene 50-50. Heater has a high altitude setting, but at 10,000 ft. It...

I used Sherwin-Williams porch and floor paint on the exterior floor pack. I did sew the fabric my self. A buddy gave me an army tent that was damaged in a storm. Mostly the frame. I had to seam it together in three places. The one on camper at this time has no windows in the fabric. I am almost...

Thank You for the kind words. I have a front dinette. My daughter is making the cushions for me. I tried to make drawers, but they were not coming out like I wanted them. In the end my counter top hinges up, and has storage dividers. My frig sits on top of my diesel heater box. I still need...

Have not weighed it yet. I doesn’t seem to bother the 3/4 ton Cummins. Sits level.

While this camper is not as slick as a factory built, I can honestly say I did it my self. With heat, solar, and a frig, I am still under 5100.00.

I have 60# lift struts. The roof with solar weights 120#. It lifts very easily and just a little tug brings it down.

I have 2 tops for camper. They are made out of vinyl covered pvc. The material used on back county or military tents. One has no windows.this camper will be used in CO during mixed alpine and ice climbing season. Will be hard enough to stay warm at altitude. I have a diesel heater installed. It...

Front dinette. The table bracket and cushions not in yet.

Could not find a reasonably priced door. Mac’s Metal made my siding, and gave me a door frame. I cut the frame down, and made door from scratch.

This is passenger side before I decided to put escape window on this side. Had to change framing.

Not all the supports are in the front wall yet. Just test fitting.

Camper frame is 1x2, 1x3, 1x4’s. I used construction adhesive, screws, and wide crown staples to fasten it together. The design is very similar the BundyTec campers. There was a article in Truck Camper Magazine with very good photos of their frames. Mine is close but not exactly the same.

Test fit in truck.

Started the floor pack. I had to build this in a barn with screenings for the floor. It was the only barn with any room left. Also had no electricity in it.