Search results

On our mid-'23 Hawk shell, the igniter on one of the burners on the suburban stove (post-recall) has quit working and I'm wanting to take a peek at it to see if it's just loose or bad wires. There is a small phillips screw at each corner on the top of the stove, and I loosened those hoping I...

Somewhere in Cali

This is OP just updating on what I ended up up doing for the wall anchors for the accessory/misc. small item storage pouches. I used these hollow door anchors https://www.homedepot.com/p/E-Z-Ancor-Stud-Solver-40-lbs-Drywall-and-Stud-Anchors-25-Pack-25225/202055965 and so far they work great...

I guess I'm not understanding why this would be... I'm no electrical engineer but if the battery is a simple tank and it's getting filled by solar and\or alternator with their connections, and is also getting filled by the noco with a direct battery connection, why would it matter what the...

Not a bad idea on the separate charging for 2 6v batteries. They are really hard to get to in my camper battery compartment to change the wiring of the charger to the 6v separately vs the way they are now however so it may be awhile for me do do that. I have the noco ring connectors bolted...

Resetting the full charge % did the trick - current charge percent now reads 100%. Voltage reads 13.2 as it did before. On this Renogy RBM500 monitor holding the single 'up' arrow when the battery is fully charged is the reset trigger. On a completely discharged battery holding the single...

There is a 6v setting on it, mine are two 6v in series tho (= 12v) so I am using the 12v setting according to mfg specs. I have the POS leg of the Noco charger on the POS post of the 1st battery and the NEG leg of the charger on the NEG post of the 2nd battery. I do not have the Noco charger...

Thanks for the tips. I'll have a peek at the monitor manual in the am.

Am using a Noco Genius 10 for first time when storing FWC Hawk camper for winter. Have 2 of the 190 amp/hr factory installed 6v Deka Intimidator AGM batteries in series for 12v. Before I powered up the Noco my Renogy battery monitor read 92% charge. When I powered up the charger a couple...

The 5/16 carriage bolt has 18 tpi - standard hardware store variety 5/16-18. I originally got these from Zoro to do the same job but they were too bulky in use in my opinion (over 4" long) and one of the three was shipped with the wrong barrel thread for the included bolt so that turned out...

I saw those and was drooling a bit. I made 2 different sized tabletops out of 3/4" bamboo to use alternately on a single set of the silver leg\post and swingarm. Both tables have the Lagun table mount for quick change if needed. I was thinking black would look nifty for the Lagun parts. I...

Thanks for all the ideas folks. I had thought of the base plate idea anchored to the known alum studs right at edge of window and opposite wall and then screwing the pouches to the base as a few have mentioned but I wasn't wanting to add more weight and material initially. I have a piece of...

I have attached some stretch mesh pockets to the inside of our hawk for extra gear storage (less than 2#) and was not able to take advantage of putting the mounting screws into the aluminum studs. As a result the mounting screws are only going into the thin paneling and insulation. I know...

New '23 Hawk owner here. Wish I had read this BEFORE I installed my Camco grab bar, esp. the part about closing the door before figuring the drill hole positions. First go I mounted the bar with holes dead center of the vertical screen door frame, nice and symmetrical-like. Close door first...

I called suburban and they were no help, the rep said they do not track stoves and manufacturing changes by serial number and could not confirm if our stove was under recall or not. HOWEVER, Brenda from FWC sent me an email today saying our stove should have the approved remedy already, with...

Just the kind of advice i was looking for - thanks all!

I'm sure this would have been covered before but apparently "fan" is a blocked search word in this forum, so that didn't help much... so am asking this anew. I'd like to put a small cooling fan in our Hawk shell anticipating camping in hot places, primarily to blow on us in the bed area at...