Search results

I would be really really sad if this size camper wasn't manufactured and marketed for our poor little tacomas. I love my ATC Bobcat on my 2010 Tacoma. Its been on the truck full time for ten years now.

Hello, I cut out wedges and then filled in the spaces with a marine grade epoxy filler.

Hello Fred, I have a 2010 Tacoma. I removed the camera from the tailgate and mounted it on the back of my camper. I used an outdoor electrical box with cover that I found at lowes or home depot, and some non metallic flexible conduit for routing the wire. I had to get some more wire and splice...

Thats a great looking shop! Thanks for the photos

Hello AK NOMAD, I have been adding rigid foam everywhere that I can, outside and inside, I added a 1/2" layer on the floor, inside the camper. I have not looked in the walls but I know there is one inch of glass bat, not much insulation but it is a light weight camper. I have added a 1/2" layer...

Here is a photo of the lower rear part of the camper where i added some 1/2" foam covered with some aluminun sheet.

Here is a photo of the support of the panel where it meets the back wall of the camper.

Hello everyone, I have been asked about this modification so here are some photos. I added a 2" foam panel to the underside of the cabover. I used stainless steel screws set thru the angle into the frame around the edge of the bed. I used Gorilla glue to secure it, the gorilla glue does not...

Great idea. Does it help with the condensation under the mattress? I might try that if it helps the inside from condension. Frank Hello Frank, The rigid foam insulation does reduce the condensation under the mattress since the panel stays warmer. I also added a 3/8" closed cell foam pad...

Thanks for the reply. For now I have to keep my 97 Tacoma with the 2.4 four and automatic. Most of the time the shell would be empty and the truck is used as a daily driver. My main concern is how the truck would handle the empty shell. I can see a full camper being to much for a smaller truck...

Bobcat next to an Eagle in Joshua Tree Nat Park.

I think I am also infected by the alumabug. Can you post some detail on the foam under the c-o? Is it straight foam or do you have it wrapped in aluminum? Its a rigid foam board with some painted plywood veener on the bottom with the edges wrapped in aluminum trim with some silicon sealant...

About the UCA for the toyota tacoma, from what I have read the aftermarket UCAs are stronger, give more articulation and provide more adjusment for alignment when the front is lifted. Also they add more clearance between the inside tirewall and the ball joint. I have noticed that with my current...

Can I ask what you did to your suspension? I have a 2011 Tacoma AC V6 4WD TRD and am considering a Bobcat camper shell with few options- aiming for minimum weight. I know our gear will still add up weight-wise. I am trying to decide what improvements to the suspension I should do. Based on what...

Good looking rig! What do you have going on under the cabover? Still trying to figure out what would be the best use of that space. Thanks for noticing! I installed a chunk of 1.5 inch rigid foam board to the underside of the bed in order to add some insulation. It keeps the inside under the...

Zion road trip 2011

Hi Everyone. I have another question. Has anyone put a Bobcat Shell on a second generation Tacoma? I am thinking about getting a new 2012 Tacoma base model with four cylinder and a five speed. I would think a new Tacoma could handle the camper better than the older Tacoma since it is a bigger...