Search results

I'm aware of the Honeywell 35f garage thermostat, but I would have to get out of bed to turn it up. I'd like a programmable, 35 degree minimum thermostat. Thanks for your help. Bill

I'd be very careful about not having a metal part of the stroller touching the roof, the vibration could rub a hole in your roof.

My bad, that is a 50 watt solar panel, not 50 amp. Bill

This camper fits an 8 ft bed. I had it in a 1995 tacoma.

** SOLD **1979 Four Wheel fleet for sale to someone who will give my old buddy a good home. The furnace and hand pump water work, there is an ice box. The lift panels work to a fashion as the top hinges front and back are shot, see picture. The two jacks are included. 50 amp solar panel with PWM...

I mounted my Renogy Rover 20 behind and above the couch so I can see it. It's only about a 2' long run to the battery box. I had to do a bit of metal trimming so when the couch is made into a bed it wouldn't pinch wires. It seems pretty good.

I pressurized the water system in my 05 Grandby and quickly had water shooting out from a cabinet. It turns out there's a little silver ring that is a compression fitting that failed so a joint on at elbow separated. Any ideas on what that ring is called and where I might find one? The nearest...

Thank you Craig for your help. The wires were really bound between the roof and the insulation. The keys for me getting them loose was to first remove the nearest roof anchor screw, then I slide a flat edge screw driver into the hole roof side and pried up on the roof as hard as I dared putting...

The Four Wheel factory provided spot on measurements on where to drill through the roof on my 2007 Grandby to find the prewired red and black wires for my solar install. I opened up about a square inch hole and tried to pull the wires up figuring the wire going toward the back of the camper is...

Hi guys, I appreciate your ideas. After rereading my post it does read I was planning to mount the solar panel directly to the roof, but I am thinking Z brackets so.. are are the roof bolts and center seam prone to leaks and needing periodic resealing? Thanks, Six5

I’d like to install a Camco Wave 3 catalytic heater for seasonal use meaning I want to remove it 8 months of the year. I called Camco and they do not make a quick disconnect fitting with a shut off valve that I would put onto a T in an existing gas line. Has anybody done this? My plan was to...

I need to cut down to 48" between the wheel wells, about 57" for the tail gate width and add about 4" in height to clear the cab. Could I cut down the floor just on the roll over bed side to eliminate dealing with all the mechanical side? If the camper is 4ish inches wider on the passenger side...