K7MDL
Senior Member
I believe the can/cover is simply held in place by bend-over tabs over the plastic insulator plate with the posts. You can likely shove it back into the can and rebend the tabs, but power it off first (at both ends).
Be sure to scope out your bed drill sites under the bed floor for where they land relative to bed support rails underneath. I prefer to drill within 1/2" of the edge of a rail so the backing plate clamps the support rail fully thus stiffening the mount and not pull up and deform your bed floor. You can move the hole locations around a bit to achieve that if needed, as long as you do not move it too far.
Be sure to scope out your bed drill sites under the bed floor for where they land relative to bed support rails underneath. I prefer to drill within 1/2" of the edge of a rail so the backing plate clamps the support rail fully thus stiffening the mount and not pull up and deform your bed floor. You can move the hole locations around a bit to achieve that if needed, as long as you do not move it too far.