I just finished building my 280amp Lifepo4. However, found that Overland Solar panels only have
2/1/2' feet of cable. I ordered 6 feet of SAE to SAE extension cable. My cells are currently about 13.25 volts. I set my Victron controller at bulk 14.0. I plugged the camper in to shore power and believed it would top off at 14.0. Shore power did not change my voltage and both my BMS (Xiaoxiang blue tooth) and Victron 100/30 show no current coming in?? All four cells remain at 13.25. I won get my SAE cable until Thursday...hoping my solar panel will show a positive current. I believe 13.25 is correct voltage as check with my monitor, victron and my voltmeter. Is something wrong....my wiring I believe I installed correctly using all negatives to the shunt...etc.
2012 Kestrel
100/30 Victron Controller
120a 4S 12 volt BMS
4 prismatic cells 280amh
Aili battery monitor with shunt
2/1/2' feet of cable. I ordered 6 feet of SAE to SAE extension cable. My cells are currently about 13.25 volts. I set my Victron controller at bulk 14.0. I plugged the camper in to shore power and believed it would top off at 14.0. Shore power did not change my voltage and both my BMS (Xiaoxiang blue tooth) and Victron 100/30 show no current coming in?? All four cells remain at 13.25. I won get my SAE cable until Thursday...hoping my solar panel will show a positive current. I believe 13.25 is correct voltage as check with my monitor, victron and my voltmeter. Is something wrong....my wiring I believe I installed correctly using all negatives to the shunt...etc.
2012 Kestrel
100/30 Victron Controller
120a 4S 12 volt BMS
4 prismatic cells 280amh
Aili battery monitor with shunt