CamperCamper
Senior Member
- Joined
- Jun 19, 2015
- Messages
- 133
There seems to be a good amount of interest in ordering a FWC Flatbed model and I count myself among the interested. I own a 2014 Hawk on a 2015 Tundra and want to replace it with a new flatbed Hawk model.
The purpose of this thread is to create a discussion among those who have purchased or researched buying, fabbing etc. the flatbed itself. Please do not turn this into a lecture about the Tundra as the appropriate platform as I am already confident in that decision.
If you have purchased a flatbed for a FWC Flatbed model (any) or considered it please share the following:
1. Who did you choose for the flatbed- name, location, why you chose them etc.
2. How difficult was the conversation with the fab shop in terms of getting it built to specs.
3. What did you learn from the process and what would you do differently if you started over.
4. How much taller does the top of the camper stand compared to a slide in model.
5. Have you experienced any failures in the frame to bed mount. Was the mount welded to the tray and then bolted to the truck frame or was the mount bolted to both the frame and the tray.
6. How much did you spend on the flatbed tray.
7. Did you paint, powder coat or rhino line the tray? Why or why not?
8. Did you incorporate a grey water system or diesel appliances?
9. What else did you utilize in the under bed cavity?
10. Any other thoughts or recommendations.
11. How did you overcome the fuel inlet slow filling problem of a flatbed design?
12. Did you incorporate your truck's backup sensors and camera into your flatbed design?
Thank you in advance for your meaningful insight and experiences.
The purpose of this thread is to create a discussion among those who have purchased or researched buying, fabbing etc. the flatbed itself. Please do not turn this into a lecture about the Tundra as the appropriate platform as I am already confident in that decision.
If you have purchased a flatbed for a FWC Flatbed model (any) or considered it please share the following:
1. Who did you choose for the flatbed- name, location, why you chose them etc.
2. How difficult was the conversation with the fab shop in terms of getting it built to specs.
3. What did you learn from the process and what would you do differently if you started over.
4. How much taller does the top of the camper stand compared to a slide in model.
5. Have you experienced any failures in the frame to bed mount. Was the mount welded to the tray and then bolted to the truck frame or was the mount bolted to both the frame and the tray.
6. How much did you spend on the flatbed tray.
7. Did you paint, powder coat or rhino line the tray? Why or why not?
8. Did you incorporate a grey water system or diesel appliances?
9. What else did you utilize in the under bed cavity?
10. Any other thoughts or recommendations.
11. How did you overcome the fuel inlet slow filling problem of a flatbed design?
12. Did you incorporate your truck's backup sensors and camera into your flatbed design?
Thank you in advance for your meaningful insight and experiences.