HI all,
I'm new here, I bought a 1972 Alaskan Truck Camper 10' non-cabover, it fits in my 1994 Dodge 3500 CTD Dually.
I am trying to start a restoration on it (slowly while still trying to use it during the warmer weather , the immediate needs are:
1-The furnace needs to be replaced - Has anyone found a solution to replace it using the existing configuration, rear exhaust, side venting by the door?
2-The stove/oven has rusted thru and needs to be replaced - any advice for a replacement (oven not really needed)
3-The wiring is a mess - When I plugged into shore power I got shocked touching the 3way fridge
4-Does someone have the pin contacts for the truck (4pin flat connector) to the camper's round 4 pin connector? The connector that came with the camper just has bear leads from the 4 pin round connector.
5-Any source for a replacement fresh water tank that will fit in the front area under the window?
6-The previous owner attached a box at the rear on the access door for the theatford toilet to hold a 10lbs tank, any ideas on how to mount 1 or 2 - 20lbs tank(s)
7-Water stains at the bottom of the upper half on both sides, maybe 3 or 4 inches up from the bottom half of the upper section. It was recommened at West Marine to soak the fibers with a diluted mixture of fiberglass epoxy resin.
I will edit pics to upload a bit later (too big for uploading right now.
Thanks
Al
I'm new here, I bought a 1972 Alaskan Truck Camper 10' non-cabover, it fits in my 1994 Dodge 3500 CTD Dually.
I am trying to start a restoration on it (slowly while still trying to use it during the warmer weather , the immediate needs are:
1-The furnace needs to be replaced - Has anyone found a solution to replace it using the existing configuration, rear exhaust, side venting by the door?
2-The stove/oven has rusted thru and needs to be replaced - any advice for a replacement (oven not really needed)
3-The wiring is a mess - When I plugged into shore power I got shocked touching the 3way fridge
4-Does someone have the pin contacts for the truck (4pin flat connector) to the camper's round 4 pin connector? The connector that came with the camper just has bear leads from the 4 pin round connector.
5-Any source for a replacement fresh water tank that will fit in the front area under the window?
6-The previous owner attached a box at the rear on the access door for the theatford toilet to hold a 10lbs tank, any ideas on how to mount 1 or 2 - 20lbs tank(s)
7-Water stains at the bottom of the upper half on both sides, maybe 3 or 4 inches up from the bottom half of the upper section. It was recommened at West Marine to soak the fibers with a diluted mixture of fiberglass epoxy resin.
I will edit pics to upload a bit later (too big for uploading right now.
Thanks
Al