King Bed Upgrade size?

JimArneson

Member
Joined
Apr 13, 2017
Messages
14
Location
Minnetonka, MN
Hello Everyone,

I just ordered a FWC Hawk (from Sean at Go Anywhere in Wisconsin) and have a question (probably not my last) about the dimensions of the bed before and after after sliding it out. I ordered the King Bed upgrade and presume that the quick sketch I made here accurately depicts the dimensions. Can anyone here confirm these are correct or point me to a more "official" set of numbers. I could not find the information anywhere myself.


Hawk%20Floorplan%20%28King%29-XL.jpg
 
Mine is a grandby and your dimensions are correct for what I have on mine. I just measured the part from start of cab to end of extension and got the additional 30" or so. Very rough measurements
 
We have a new Grandby with the king bed. I just went out and measured the bed at 77" wide and 75" long. It has a 47" x 77" cushion and four 14" x 38-1/2" cushions. I don't know if the Hawk has a larger bed than our Grandby
 
We're debating getting the King bed upgrade also. How is it? Sleeping N->S has gotta be nice. Any regrets?

Steve
 
Gotta be honest... Have not yet been out overnight in the camper. I have pulled the bed all the way out and tried it out. It seems really nice and is certainly spacious.

The Eclipse in Nebraska was our last camping adventure before my kids went back to school. We camped using our Roof Top Tent (on the pickup). Was hoping the FWC would be delivered in time... But it was not.

IMG_0139%282%29-XL.jpg


20170820_201220%282%29-L.jpg
 
King size option is well worth it in my opinion. Plenty of room and no climbing over for the late night wake ups.
 
Isn't it a pain to always be making and unmaking the bed every night? We have the queen option and find ourselves pushing it in so that we can both sit at the table in the morning. Not a huge deal but a minor annoyance. I wish we had a few more inches of head room (taller pop up portion like the fleets) for easier maneuvering into and out of the bed area.
 
fireball said:
Isn't it a pain to always be making and unmaking the bed every night? We have the queen option and find ourselves pushing it in so that we can both sit at the table in the morning. Not a huge deal but a minor annoyance. I wish we had a few more inches of head room (taller pop up portion like the fleets) for easier maneuvering into and out of the bed area.
I don't mind the maneuvering. In the Grandby there is still enough room to sit at the table with the bed fully slide out.
 
We have the king bed option in our Hawk shell (with furnace, cooktop and side dinette) and would never consider NOT getting the king option. If you don't want to pull it out to king, you don't have to. Use it as a Full not pulled out at all. Use it as a queen with two cushions. Use it as a king with all four extra cushions and sleep north/south. We sleep north/south every night we use it. It is very nice to crawl in and out without bothering the other person.

Yes it takes up a lot of room when pulled out, but I am usually the first person up, get dressed and go outside for a bit. Then my wife gets up changes and when she goes outside, I slide the bed back and organize. I'm usually done by the time she comes back (less than 4 or 5 minutes). We've also slid the bed back in with both of us in there. A bit tight, but not bad at all. Just faster and easier when one person is outside. A small inconvenience for the benefit it provides. And again, only pull it out as far as you want or need.
 
I agree w. Chadx I extended my hawk bed to 78"w x 79"L but you see out all 4 windows and it's a minor annoyance to close up. The plus for me is I roll around like a kid when asleep. I used a 12"x 78" extension w/ piano hinge so it gives many combinations of extensions
 
Jim, I'll have to check when I next pop the top (I should have measured when we were out this weekend), but it seems to me our king is longer than 75". More like 80"+. I know it's longer than the 77" width. I'm 6' and my wife is 5'10" and sleeping sideways was too crowded with only 5 inches to split between headroom and footroom. The king gives us way more room. Definitely more than the 77" width measurement. How much will have to wait until next weekend but seems to be 80 - 82" or so.

Ours is a 2017 Hawk shell. Maybe different models or years are different? But then maybe not since they are simply supplying four cushions rather than two.

Edit: Since we use different foam in the camper than the stock cushions, I decided to pull out the stock cshions and measure those. Unlike Camper Rich, who reported cushion sizes of "It has a 47" x 77" cushion and four 14" x 38-1/2" cushions."
My hawk king cushions are 16" wide rather than 14" and 48" rather than 47".
16" × 38.5" (four cushions)
48" × 77" (one main cushion)

So 48"+16"+16" = 80" long. So our king pullout is 77" wide × 80" long.
 
OK guys I'm old and my wife and I were not using the queen size extension for our Hawk. We just completed a 3 week trip and we did. As some have suggested it takes more space and the issue of tearing down each morning. We dealt with that BUT my wife id 5'4" and it was very difficult for her to get in and out when extended. Not much to step on ad extends over the front seat and we have side dinette. I know some are using a ladder setup and I'd like suggestions or alternatives. Sorry about post hijack :(
 

New posts - WTW

Back
Top Bottom