I am in the process of designing a truck camper. It is an aluminum construction with signabond exterior cladding, Insulation, and then wood interior walls. 1.5" 11-12g aluminum square tubing (overkill?).
The roof will be a full pop top and I am having trouble designing the seal and understanding how to make to make it look clean and flush when down while also being as watertight as possible. Can someone show me what a section cut of the pop top seals look like or point me into direction where there are some available?
I understand I would use a Bulb style rubber trim, but I'm confused on how the canvas meets the bottom half of the unit without having water intrusion.
The roof will be a full pop top and I am having trouble designing the seal and understanding how to make to make it look clean and flush when down while also being as watertight as possible. Can someone show me what a section cut of the pop top seals look like or point me into direction where there are some available?
I understand I would use a Bulb style rubber trim, but I'm confused on how the canvas meets the bottom half of the unit without having water intrusion.