Source for siding

[Skeeter]

I am looking for a source for aluminum siding to replace the damaged panels on my Ranger II. Living here in Phoenix should be a plus. Does anyone know of a place where I can get this stuff? I plan on replacing the entire left side due to the fact that my camper is a shell and all those access panels are just holes. Thanks again for all great ideas and help. I also just traded the Dometic fridge for a Fantastic fan, and I also scored this stirling cooler that is much more efficient. -Joel
[URL="http://www.wanderthewest.com/forum/picture.php?albumid=20&pictureid=489[/IMG[/IMG"]http://www.wanderthewest.com/forum/picture.php?albumid=20&pictureid=489[/IMG[/IMG[/URL]]
[IMG][IMG][URL="http://www.wanderthewest.com/forum/picture.php?albumid=20&pictureid=490[/IMG[/IMG"]http://www.wanderthewest.com/forum/picture.php?albumid=20&pictureid=490[/IMG[/IMG[/URL]]
[IMG][IMG][URL="http://www.wanderthewest.com/forum/picture.php?albumid=20&pictureid=491[/IMG[/IMG"]http://www.wanderthewest.com/forum/picture.php?albumid=20&pictureid=491[/IMG[/IMG[/URL]]
[IMG][IMG][URL="http://www.wanderthewest.com/forum/picture.php?albumid=20&pictureid=492[/IMG"]http://www.wanderthewest.com/forum/picture.php?albumid=20&pictureid=492[/IMG[/URL]]

 

[5 Speed]

I have a similar soft dent

I backed into a bush and have a soft dent on my rear passenger side, I would like to know where to get the material too Maybe we can get a group buy together!

 

[Skeeter]

Marty at ATC was very helpful in locating some siding material and how to staple it to the frame. I will update this post during my repair. I decided to go ahead and replace all of the skin so my Ranger will get a new look. -Joel

 

[rich]

Joel,

Sounds like a fun project. I'm considering doing the same to the fleet that I just bought. What's the cost on a full set of siding?

 

[Skeeter]

Rich,
So far, it looks to be around 375 to 500 dollars for all sides. ATC was the cheapest, but that means a trip to the factory to pick it up. I am trying to find a supplier here in Phoenix to shorten my drive! Marty said that it was a very easy job stapling the siding on. I will post. -Joel

 

[rich]

Rich,
So far, it looks to be around 375 to 500 dollars for all sides. ATC was the cheapest, but that means a trip to the factory to pick it up. I am trying to find a supplier here in Phoenix to shorten my drive! Marty said that it was a very easy job stapling the siding on. I will post. -Joel


Nice, that's not bad at all. I was going to just spruce up my fleet a bit but the more I'm getting into it I might just do a down to the frame rebuild on it. Especially if it's only $350, t0 $500 to re-skin it!