Search results

1st went to someone in PDX for parts, still using the rear side dinette but is on last legs, will be scavenging fittings etc for the third that is being fixed up currently. Will l see if have pics from before it got partially turned into a mobile workshop (with a co bed) - is an '84 built by a...

http://www.wanderthewest.com/forum/topic/4747-replacing-3-way-fridge-with-compressor-fridge/?hl=novakool#entry52109

I have a similar setup on one side of mine that holds three 5 gallon fuel cans, nozzle and a rescue/crash axe.

or get a 4 gallon oil change 'jerry can' like collection can from wallyworld. They carry easily. http://www.walmart.com/ip/16qt-Oil-Drain-Container/44580714

Do you have any contact info? And do they do their aluminum widthwise (8', 10', 12', 14' etc plus the inch at each end to bend down) or it strips (about 4' wide so you need 5 to do the roof and sides - with 2 seams in the roof)

Do you have a template for the end wall or did you just eyeball it...

over 80" needs corner clearance only or the middle triple set as well?

On the 10' get a pair of the up/down guides and install in the middle of the side. You will have to shorten down the part that goes on the top so it doesn't block the window when up. That will keep the sides about at the original separation. I was getting ready to start replacing my Pirelli...

Thanks - loved your thread BTW. Stored all pics for reference! Especially using stainless exterior hardware/brass interior. Also wondering about sealing all the wood frame before adding the panels, and the panels on both sides before mounting. Then another coat before placing insulation and...

in Portland but out of town in CA for a while. Still have? If so how soon do you want gone (back Oct 23-25). kenlawsonwilliams@hotmail.com 9168994560

fumes exit the lower half and being hot, rise up and get past pirelli seal into upper section. New seal and positive pressure (vent fan will make worse, need it to draw outside air in so it exits through the seal)

After about a year of living in an '84 10' CO rear side dinette model I have discovered a few design things I would like to change on a rebuild. But has anyone else have any ideas that they have discovered? - Push/pull pins and steel plates to lock the camper in down and up position -...

Rear side dinette style, restoreable not a rebuild candidate like my current '84

F350 1971 dually in Klamath Falls (Oregon). Under the hood is a 390 motor (8 cylinder) 4 speed manual, generator, air condition, and gas to propane set up.

'84 10'CO rear side dinette - picking up a dually D70HD axle to swap into the M1031 CUCV

still available?

Anyone know of a source, have one for sale, seen plans to sew one - a storage cover that will fit an Alaskan when down?