WyomingJames
Member
- Joined
- Jun 4, 2015
- Messages
- 14
Hi all, I am a newbie here although I have been following several posts to get ideas. I have purchased a 1983 FWC Keystone camper 2 months ago and as most campers this age, it is in need of alot of TLC. I am going to try to avaoid a total rebuild at this point and attempt get it in shape to use this summer. I have already started a floor pack narrowing and built & installed a front lift panel. As others have done, I will attempt to post pictures when I can.
I have a question I have not found an answer to and thought there is alot of very experienced people on this site that may be able to answer my questions (I am sure there will be a lot more in the near future).
My question is, I need to add access holes to get to the turnbuckles. I see FWC commonly uses a rectangular hole and a round hole. Do they use a round hole because two rectangular holes would weaken that panel too much?
Thanks for any help anyone can give?
I have a question I have not found an answer to and thought there is alot of very experienced people on this site that may be able to answer my questions (I am sure there will be a lot more in the near future).
My question is, I need to add access holes to get to the turnbuckles. I see FWC commonly uses a rectangular hole and a round hole. Do they use a round hole because two rectangular holes would weaken that panel too much?
Thanks for any help anyone can give?