I sold the customer that camper.
It was of the first few hard top cabover FWC we built.
And it is a BIG camper.
Full hard sides 9.0 foot long cabover camper.
The pictures are a bit deceiving.
We picked up the camper and brought it back to our shop a couple of weeks ago.
When the camper arrived and they had it off the truck, I looked the camper over and looked all 4 corners and the camper jacks.
I could not even tell what jacks were pulling away?
All 4 camper jacks looked really straight.
No frame damage, no bending in the corners that I could see.
But when I looked under each corner (like the pictures) I could see the small gap there.
It is not from the turn buckles.
The turn buckles (when attached) are pulling the jacks downwards and in towards the sides of the truck.
The small space at the bottom of the jacks is pulling outwards (away from the truck bed), so it could not be from the camper tie downs.
Tom has taken pictures and is working with the guys in our shop to try and determine what happened or what is happening.
I don't know where there are with it, but Tom is handling it right now.
The brackets might just need to beefed up a little, or it could have been customer error.
We are not sure.
They are just trying to figure out the details so we can get er' fixed and back on the road again.
Just thought I would give you the entire story up to this point.
.