Josh41
Senior Member
It is time to start customizing out Fleet shell. On the driver's side, we want to put in a counter with space below for bins, so the face will be open with a few support legs.
1. Any thoughts on materials, looking for light, with out sag.
2. We will add an Atwood furnace or whatever FWC is using now in the fall. Is there a depth requirement for the heater? We will box the heater in and I want to make sure the counter comes out far enough to make a cabinet for the heater.
Under the pull out bed by the front window, we are planning a filler to make an almost twin bed, abut 28" wide and the width of the camper. Looking for a material to span the floor that we can convert during the day to a table. Bonus points if it can match the counter.
Josh
1. Any thoughts on materials, looking for light, with out sag.
2. We will add an Atwood furnace or whatever FWC is using now in the fall. Is there a depth requirement for the heater? We will box the heater in and I want to make sure the counter comes out far enough to make a cabinet for the heater.
Under the pull out bed by the front window, we are planning a filler to make an almost twin bed, abut 28" wide and the width of the camper. Looking for a material to span the floor that we can convert during the day to a table. Bonus points if it can match the counter.
Josh