So, today I first cleaned off the roof with some rubbing alcohol and a towel. Then I laid the panels down where I wanted them and traced the outside edge with a pencil. I utilized the edge of the Yakima Tracks as a guide. I'm not too worried about the shade they might cause and it's unlikely I'll use the racks anytime soon, as long as I have my trailer to haul my kayak around. After that I removed the panels and laid down a nice amount of the 3M Marine 4000 UV Fast Cure Sealant. Then set the panels in place, pressed them down pulling them towards me while using a towel. Dang things were hot! The last thing I did was to place a towel, plywood and then bricks on each panel to insure good adhesion. I checked my solar charger before covering them and the batteries were reading 99%. After covering them my remote panel was still feeding the unit at 90%. So, now I can charge the batteries with the alternator from the truck, the 30 amp shore power, and 300 watts of solar.