FoxenTec
Senior Member
I would be hooking them up in parallel to a MPPT Controller.
Thank you
Thank you
This was changed to overland solar correct? These attached to a rigid backing so they are not glued to roof. Gluing flexible panels to roof will kill them quickly, as they need to be able to cool.longhorn1 said:I believe FWC uses Zamp for the solar panels
On my 2018 Grandby flatbed model the solar panel is approximately in the middle. I don't remember where the solar plug is and the camper is at the flatbed place getting the underbed boxes mounted.FoxenTec said:Can someone indicate where on the top of a Four Wheel Camper they are now installing the roof mounted SAE port? Ours will be a Grandby with two roof vents and I wondered where on the shell they place the SAE connector? I would assume it would be towards the rear of the camper on the side but I saw a picture of someones camper on this site and it looks more like in the middle but I wasn't sure I was looking at the SAE connector.
Thank you!
On my Hawk slide in, it’s about 1 foot REAR of the front vent, if that makes sense.FoxenTec said:Can someone indicate where on the top of a Four Wheel Camper they are now installing the roof mounted SAE port? Ours will be a Grandby with two roof vents and I wondered where on the shell they place the SAE connector? I would assume it would be towards the rear of the camper on the side but I saw a picture of someones camper on this site and it looks more like in the middle but I wasn't sure I was looking at the SAE connector.
Thank you!
They started using Overland Solar mid-2018 (see my post above). Before that it was Zamp panels, not sure about the controller.Oilbrnr said:Who makes the charge controller? The '17 I have has Victron (which is nice). Not sure if the PO swapped it, or if that is what FWC was installing then.