Replacing the Iota DLS-30 in a 2010 Grandby

[Bdold]

Has anyone done this? Do I need to remove the entire cabinet face?

 

[Stan@FourWheel]

I have never seen one go bad before, but not to say it can't happen.

Have you checked and replaced the fuse yet ?

99% of the time, the fuse is the problem, if it is not working.

 

[ClimberRob]

Mine was quite challenging to remove. There are four nut/hex-head screws. The front of the cabinet cover comes off easily with four screws. Then the front two screws into the IOTA area easy. For the back two, I had to get a 1/4" socket with extension fed in there and could just barely feel the tip of the screw head with my finger to place the socket, then slowly back the screw out 1/4 turn at a time.

I eventually figured out that the reason mine was not working was that it was never wired in from the factory. Oops! Wires sitting new/untouched/unstripped behind the unit. Very happy with the Victron unit I replaced it with, though.