Propex Heatsource Furnace in pop up camper.

[DMCK]

First post for me here, stumbled onto this thread while researching a propex heater for my Tufport T65 shell. Lots of great info here.
With the propex Intake / exhaust, I was thinking of install in bottom rear corner, and have intake come in through the bottom overhang with thru-hull fitting, and exhaust out the back with a thru- hull again. Is this doable, make sense? I haven’t bought heater yet, but was leaning towards Propex.
Thanks Dave….

 

[ski3pin]

DMCK, welcome to Wander the West and good luck with your project!

 

[Wandering Sagebrush]

Welcome to WTW! That is a nice looking shell, hopefully you’ll have a thread on your build!

 

[Vic Harder]

Propex makes a dual thru-hull fitting that you can route both intake/exhaust to. Might be easier than drilling two holes?

 

[DMCK]

I seen that after I posted. Agreed it looks easier, just routing the hoses, how much bend can I do? Was thinking the the 2211 could maybe be mounted higher up and then go straight out the side with the dual thru hull. 2211 can be mounted on its side.

 

[Vic Harder]

I mounted my Propex 2600 sideways under the kitchen sink cabinet, intake/exhaust go through the plywood floorpack on the side by the driver's wheel well. I routed the intake forwards, the exhaust exits towards the rear.