PokyBro
Senior Member
The Velcro loop material I purchased was two inch wide. I marked and cut a 3/4" strip to use for the clear vinyl window, and used the remaining 1-1/4" for the privacy flap.
Once these panels were all made, I attached the two panels onto the Velcro hook strips on the side liner windows, carefully stretching the screen window straight, and making sure they were lined up properly, before sewing them in place at the bottom corners, leaving the bottom edge of the flaps, about 3/4" longer than the window opening, as they are fitted through a 3/4" slit, allowing them to go to the outside of the liner, and the screen material wrapping around, and behind, before the bottom edge is sewn shut, as follows.
Sent from my iPad using Wander The West
Once these panels were all made, I attached the two panels onto the Velcro hook strips on the side liner windows, carefully stretching the screen window straight, and making sure they were lined up properly, before sewing them in place at the bottom corners, leaving the bottom edge of the flaps, about 3/4" longer than the window opening, as they are fitted through a 3/4" slit, allowing them to go to the outside of the liner, and the screen material wrapping around, and behind, before the bottom edge is sewn shut, as follows.
Sent from my iPad using Wander The West